GRAUPNER micro EC 135 Manuel page 30

micro EC 135
indoor
How to change the stick mode
The assignment of the sticks to the control functions can be changed. You may wish to do so if
you are already a model helicopter pilot used to a different stick mode.
In all other cases you should use the default mode 2 as it is factory set up.
For changing the stick mode you have to open the transmitter case. Having removed the four
screws in the back pannel you can remove it, too. For easier access you may disconnect the
power supply plug from the pc board.
Locate the two mode switches on the small auxiliary pc board above the trainer socket which are
used to select one of the four standardized stick modes.
Fig. (10)
If you select mode 1 or 3 (throttle control righthand side) you also have to move the neutralisa-
tion unit for the pitch stick and the rachet for the throttle stick to the opposite sticks as shown in
Fig. (11).
Fig. (11) Throttle control righthand side
12