Publicité
Les langues disponibles
Les langues disponibles
Malfunction
Malfunction
and Weld-
ing procedure LED dis-
plays
light up
Malfunction
and Weld-
ing complete LED displays
light up
Malfunction
and Ready
for welding LED displays
light up
Malfunction,
Welding
procedure
and Ready
for welding LED displays
light up
Malfunction
flashes
9007201520403851-1 © 05-2017
967.778.00.0 (01)
Cause
Defective Geberit electrofusion
sleeve coupling or defective
Geberit electrofusion tape for
anchor point
Sleeve connection plug re-
moved during the welding pro-
cedure
Electrofusion machine is over-
heating or operating at too high
an ambient temperature
Operating at too low an ambi-
ent temperature
Fault current while welding,
e.g. as a result of moisture on
electrical connections
Electrofusion machine is de-
fective
Rectification
4 Disconnect the mains plug.
4 Visually inspect the contacts
on the sleeve connection
plugs and dry or clean them
if necessary.
4 Use a new Geberit
electrofusion sleeve coupling
or a new Geberit
electrofusion tape for anchor
point.
4 Disconnect the mains plug.
4 Press the start button and
hold for three seconds.
4 Repeat the welding
procedure with the cooled
Geberit electrofusion sleeve
coupling or the cooled
Geberit electrofusion tape for
anchor point.
4 Let electrofusion machine
cool down until the trouble
indication goes out.
4 Do not expose the
electrofusion machine to
direct sunlight.
4 Only operate the
electrofusion machine in the
permitted temperature range.
See also chapter Technical
data.
4 Disconnect the mains plug.
4 Keep electrofusion machine,
all cables as well as Geberit
electrofusion sleeve coupling
or Geberit electrofusion tape
for anchor point dry and
clean.
4 Send the electrofusion
machine to an authorised
repair shop. For addresses
of authorised repair shops,
contact your Geberit sales
company or visit
www.geberit.com.
EN
25
Publicité
