Geberit ESG light Manuel D'utilisation page 22

EN
Operation
Welding with the Geberit
electrofusion machine ESG
light
The Geberit electrofusion machine
ESG light is equipped with an
automatic mechanism which
prevents a double weld when a
coupling connection cable is
connected.
The required welding time is
adjusted automatically in accordance
with the ambient temperature.
Prerequisite
– Pipes, fittings and welding joints are dry
and free of dirt.
– Pipes and fittings are prepared in
accordance with the installation manual
for Geberit electrofusion sleeve
couplings.
– Pipe surfaces are prepared in
accordance with the installation manual
for Geberit electrofusion tape for anchor
point.
22
WARNING
Danger of fatal electric shock
4 Do not weld wet or water-filled
pipes.
4 An isolation transformer must
be included in the circuit when
carrying out electrofusion work
in damp areas.
4 Allow the Geberit electrofusion
sleeve coupling or Geberit
electrofusion tape to cool down
before conducting a secondary
welding procedure.
CAUTION
Risk of injury from burns
4 Do not touch the electrofusion
sleeve coupling or
electrofusion tape, plug
contacts and pipe during the
welding procedure or during
the cooling-down phase.
ATTENTION
Leaking connection caused by faulty
welding
4 The pipe to be welded must be kept in a
tension-free position during the welding
procedure and the cooling-down phase.
4 Air draughts through the pipe interior
must be avoided.
9007201520403851-1 © 05-2017
967.778.00.0 (01)