Thane Fitness OrbiTrek PRO Manuel Du Propriétaire page 9

Owner's Manual
VI. Attaching pedal tubing to the crankshaft
Note: Pedal hinge bolts and lock nuts are marked (R) for right and (L) for left.
Attach the right and left pedal tubing (#4R & 4L) to the crankshaft (#38) using right and left 1/2" pedal
hinge bolt (#35R & 35L) the 1/2" spring washer (#67) and 1/2" lock nut (#66R & 66L). Be sure to keep
the hinge bolt straight as it goes through the pedal tubing to meet the crankshaft. If the hinge bolt is
connected to the crankshaft at an angle, it will not be fully fastened by the spring nut and damage to
both the hinge bolt and crankshaft may occur. Align the right pedal tube (#4R) underneath the foot
pedal (#55R) to the right-side crank and thread the pedal hinge bolt by hand until you can no longer
turn it. Then take an Allen Wrench and continue threading the bolt clockwise until it is flush with the
pedal tube. Place the washer on (#67) and then the lock nut (#66R) onto the inside of the bolt. Tighten
down the lock nut with the preformed wrench.
Note: The right pedal hinge bolt (#35R) tightens the lock nut clockwise and left pedal hinge bolt (#35L)
tightens the lock nut counter clockwise.
35L 4L
Fig. 5
38
66L
67
4R
B
35R
A
66R
8