Thane Fitness OrbiTrek PRO Manuel Du Propriétaire page 11

Owner's Manual
VIII. Tension adjustment
The assembly of your OrbiTrek Pro is now complete. As you try it for the first
time, you should adjust the tension to a desirable level before you begin a full
workout. To increase tension turn the tension knob to the right and to decrease
tension turn the tension knob to the left.
IX. Reversable movement
Remember, your OrbiTrek Pro has REVERSIBLE movement!
Forward pedaling emphasizes your quadriceps muscles (front thighs),
while backward pedaling emphasizes your hamstrings (back thighs).
Take advantage of this fact to make your workout less fatiguing,
and more fun.
X. Electronic monitor
With the press of a button, you can set the electronic monitor of your OrbiTrek Pro to display
the following information:
• SCAN – press the "MODE" button until "SCAN" appears. The monitor will rotate through all
4 functions: speed, distance, timer and calories every 30 seconds
• SPEED – press the "MODE" button until "SPD" appears. The monitor
will display how fast you are running.
• DISTANCE – press the "MODE" button until "DST" appears to find
out how far you would have run with your two feet on the ground.
• TIME – press the "MODE" button until "TMR" appears to find
out how long you have been exercising.
• CALORIE – press the "MODE" button until "CAL" appears to
accumulate the calorie consumption.
• RESET – by pressing the "RESET" button for more than 1
second the monitor will reset all functional values to zero.
The SCAN mode lets your monitor automatically alternate the four read-
outs in short intervals, so you don't have to stop and press a button to check different information.
The monitor comes with a AA battery and turns itself off when not in use to conserve energy.
How to replace battery
1. Push in and hold small tab, on back of unit, with thumb and lift.
2. Remove battery
3. Replace with one Size AA or UM-3 battery.
4. Make sure battery is positioned correctly. The end marked with –
must be in contact with the spring.
5. If the display becomes illegible or only partial segments appear, please
take out the battery, wait 15 seconds, and reinstall
6. Battery life is approximately one year under normal usage.
7. Removal of battery will reset all functional values to zero.
10
Tension
Control Knob