Thane Fitness OrbiTrek PRO Manuel Du Propriétaire page 10

Owner's Manual
A nylon ring can be seen at the rim inside
the spring nut. The hinge bolt must fully
penetrate this nylon ring.
CORRECT
INCORRECT
INCORRECT
35L
Counter Clockwise
VII. Attaching the handlebars
Handlebars
You can easily switch your handle bars
(#3R & 3L) between the dual action mode
and the fixed mode during your work out.
Dual Action Mode: To allow the handlebars to
move along with the pedals, insert them into the
coupler bar. The handle bars are identified with
R & L stickers indicating Right and Left. Select
a height that is comfortable and lock it in place
with knob bolt (#25).
Fixed Mode:
To keep the handlebars stationary, attach them
to the tubing on the main frame between the
coupler bars. As with the dual-action mode, set
both handlebars at the same, comfortable height
and secure them with the same knob bolts.
IMPORTANT!
The hinge bolt (35R & 35L) must fully penetrate
the nylon ring inside the spring nut (66R & 66L).
This will ensure the stability and durability of
your OrbiTrek Pro.
In order to install the hinge bolt properly, keep it
perfectly straight as the bolt goes through the
pedal tubing and the crankshaft. If the hinge bolt
is connected to the crankshaft at an angle, damage
to both the hinge bolt and the crankshaft may occur.
35R
Clockwise
3L
5L
9
FIXED
MODE
3R
25
Fig. 6
5R