Grafik Eye 4000 Serie Mode D'emploi page 23

ZONE 5 ZONE 6
ZONE
raise/lower
buttons
LED Displays for Temporarily Changing Shade Settings
Scene Status/Control
Affected/Control unit
Unaffected/Control unit
Affected/Wallstation
Unaffected/Wallstation
Legend:
LED lit
LED off
R
TEMPORARY
LED
FADE TEMPORARY
TEMPORARY
ZONES
M S
ZONES
MASTER
AC Shade Zones
Stopped Raising
To temporarily adjust a Sivoia QED
zone:
1. Press the TEMPORARY ZONES button so the
TEMPORARY LED above the TEMPORARY ZONES
button lights.
2. Press the ZONE 5 or 6 button to adjust any
zone's shade position to a preset position.
3. Use the raise/lower buttons on the wallstation that
controls the shade zone to adjust it to a position that
is not a preset.
To temporarily adjust an AC shade zone:
1. If fully open, press the ZONE 6 button. At the
desired position, press the ZONE 6 button again to
stop the AC shade.
2. If fully closed, press the ZONE 5 button. At the
desired position, press the ZONE 5 button again to
stop the AC shade.
Lowering Stopped
GRAFIK Eye 4000 Series Control Unit Installer's Guide 23
®
Sivoia QED Shade Zones
Raising Lowering
shade
TM