Program Scenes 1 Through 16 (Setup Mode) - Grafik Eye 4000 Serie Mode D'emploi

Program Scenes 1 through 16 (Setup Mode)

You can program any scene using setup mode. If your lighting system requires more than 4 scenes, scenes 5
through 16 must be programmed using setup mode.
NOTE: To program scenes 1 through 4 using Sd save mode, refer to page 18.
Select flashing Sc/1
2
ZONE 1 ZONE 2
4
Program lighting
or shade scene
settings for each
zone
ZONE 5 ZONE 6
4
To set unaffected zone,
press ZONE twice
6
and then hold until mid-
dle three LEDs light
20 GRAFIK Eye 4000 Series Control Unit Installer's Guide
®
5
Set scene's
fade-in time
FADE TEMPORARY
3
ZONES
Select scene
M S
MASTER
FADE TEMPORARY
ZONES
M S
MASTER
To program scenes using setup mode:
1. Enter setup mode. Press and hold the SCENE 1
and OFF buttons for about three seconds until the
scene LEDs start cycling.
2. Select Sc (scene setup) by pressing the
FADE 5 button twice. Sc and 1 (scene 1) will
alternately flash in the FADE window.
3. Select scene. Press the MASTER 5 or 6
button to select the number of the scene to be
1 6
,
programmed (1 through 15; 0 is the OFF scene).
4. Program scene settings for each zone.
Enter (exit)
setup mode
For lighting zones, press the ZONE 5 or 6
button to set the zone intensity. (GRX-3500 units
will display exact percentage light output; press
again to adjust light levels in 1% increments.)
For AC shade zones, press the ZONE 5 or 6
button until the ZONE LEDs match the right shade
position for this scene. See the illustration on page
18.
For Sivoia QED shade zones, press the
ZONE 5 or 6 button until the ZONE LEDs match
the right shade position for this scene. See the
illustration on page 18.
For unaffected zones, press and hold the
ZONE 6 button until all its LEDs go out and the
middle three LEDs light (this may take up to 10
seconds). This zone's settings will not be affected
when this scene is selected.
To reprogram an unaffected zone as affected,
follow the steps above. Then press the ZONE 5
button for about three seconds until the middle
three ZONE LEDs are no longer lit. Program the
zone's settings.
5. Set the scene's fade-in time. Press and hold
the TEMPORARY ZONES button. The current fade-
in time will be displayed. Adjust using the FADE 5
or 6 button while still holding the TEMPORARY
ZONES button. (Fade time does not apply to shade
zones.)
6. Exit setup mode. Press and hold the SCENE 1
and OFF buttons until the LEDs stop cycling.
R