Publicité
Les langues disponibles
Les langues disponibles
Starting Cooking
When you start cooking, we recommend turning up the heat source to the
highest setting so that the required pressure is reached as quickly as possible
in the pot. Please bear in mind that you should never fill the pressure cooker
above the interior filling mark ("Maximum"). Otherwise the food being cooked
could soil the valve.
The safety vent will be pressed upwards by the pressure created in the pot and
will block the opening button. When the pressure cooker is under pressure it
cannot be opened.
As soon as steam comes out of the pressure regulating valve, this means that
there is sufficient pressure in the pressure cooker. You can now turn down the
heat so that the pressure is maintained but not too much steam escapes. Timing
starts from this point onwards.
Opening the Pressure Cooker
Turn the settings knob to "Steam Release Function" (see fig. 6, page 19). The
steam will escape. Please wait until the safety valve falls downwards and the
release button permits the pressure cooker to be opened. Push the release
button in the direction of the cooker. Now turn the lid to the right to open the
cooker.
NEVER USE FORCE TO OPEN THE LID !
Abb. 7
21
Care and Maintenance
After use, wash your pressure cooker with hot water and a non-abrasive
washing-up liquid. The lid and rubber gasket cannot be washed in a dishwasher.
The rubber gasket must not be washed with washing-up liquid. After
washing, the pot and the lid should be dried thoroughly and stored with the lid
facing upwards. It is not a good idea to put the cooker away with the lid
closed, as this will cause the rubber to deteriorate more quickly.
Cleaning the Safety Vent
To clean the safety vent, first loosen
the holding screw (see fig. 8). You
can then lift the safety vent out and
clean it thoroughly.
The safety vent may not be
divided!
Removing the Pressure control valve
To clean the silicone sealing ring, please remove the pressure control valve
(see fig. 6, page 19).
fig. 7
E
P
PL
CZ
H
RO
GR
Holding screw for safety vent
(marked red)
BG
Silicon seal for
pressure regulating valve
22
UK
F
I
fig. 8
fig. 8
Publicité
