Recommendations; Maintenance - JANE MATRIX LIGHT 2 Manuel D'instructions

_ RECOMMENDATIONS

Keep this instruction book for future reference. Always keep it in the
pocket inside the seat.
Ensure that inside the car, both luggage and any other object liable
to cause injury in the event of an accident are properly fastened or
stored.
The MATRIX LIGHT safety seat should be properly fixed with the safety
belts, even when not in use, as in the event of an accident it may be
thrown about, causing injury to the occupants of the vehicle.
Remember not to use the MATRIX LIGHT safety seat in cars fitted with
a front airbag, unless it is disconnected or disabled, for which you
should consult the car manufacturer or retailer.
You can access the link: www.janeworld.com for further information on fitting your new MATRIX LIGHT.

_ MAINTENANCE

Do not expose the cover to sunlight for long periods. When the seat is
not in use, cover it or store it in the boot.
Wash the plastic parts with warm water and soap, carefully drying all
the components afterwards.
The upholstery can be removed for washing. Follow the instructions
below:
• Unfasten the safety harness clip and pass it through the slot in
the upholstery.
• Take off the rubber bands that go underneath the car seat belt
fasteners.
• And take off those that are on the base next to the handle.
• Take the upholstery off the MATRIX LIGHT safety seat.
• Undo the Velcro strips that are in the area of the seat belts and
pull the upholstery.
Wash by hand at a temperature never higher than 30° C.
To refit the cover, follow the same steps in reverse order.
For your safety and the good conservation of this product, it is impor-
tant to bring it to one of our official workshops for regular inspections.
EN 25