Cleaning; Dismantling Of The Facia - Helios ultra Silince MiniVent M1/150 F Notice De Montage Et D'utilisation

Installation and Operation Instructions
CHAPTER 5

CLEANING/

DISMANTLING
WARNING
WARNING
MiniVent M1/150 F
7. Overrun
After the deactivation of the respective stage, the fan will deactivate after the set overrun time. The length of the overrun
time is adjustable (6, 10, 15, 21 minutes). It can be deactivated for the required ventilation, but not in automatic mode.
When switching between the stages, the overrun time is ignored. In case of the simultaneous deactivation of both sta-
ges, the applicable overrun time of the controller can be ignored. As one switch is always technically faster, the reaction
of the controller depends on the last switch
.
5.0 Cleaning
WARNING!
An insulation fault may result in electric shock!
Before cleaning, isolate the fan from the mains power supply and secure against being switched on again!
– Clean facia, protection guard and visible casing parts with a damp cloth
– Do not use aggressive, paint-damaging cleaning agents!
– High pressure cleaners or jet water is not permitted!
5.1

Dismantling of the facia

WARNING!
An insulation fault may result in electric shock!
1. Before dismantling facia, isolate fan from mains power supply and secure against being switched on again!
2. By pulling on the outer edges, the facia – can be unlocked and removed (fig.2/3).
fig.2
–
By pulling on the outer edges,
the four snap-in hooks will
unlock
fig.3
Remove facia
7
–
UK