Installation and Operation Instructions
NOTE
MiniVent M1/150 F
fig.9
8 mm
- Length of single conductors 135 mm
- Stripping length 8 mm
- Strip sheathed cable flush with cable duct
6.5
Mounting
fig.11
Duct channel
90° bend
Assembly in cramped
6.6
Operation
In order to ensure the smooth functioning of the fan, the following must be checked on a regular basis:
- Appearance of dust or contaminant deposits in the housing or on the motor and impeller
- Freewheeling of the impeller
- Occurrence of excessive vibration and noise
In case of problems with one of the aforementioned points, maintenance must be carried out according to the
instructions in chapter 8.
fig.10
1. Place and screw terminal compartment cover on
plastic casing (Pos )
2. Then place and snap-in facia
fig.12
Mount guide
Ventilator
vane with
back draught
shutter at the
end of the
duct or just
omit it.
conditions
Room side
11
WES 1.. or
TWH 1..
Core drill
hole
M1/150 =
Ø 160 mm
Guide vane with
back draught
shutter
Standard installation
utside
UK