Struers RotoForce-1 Mode D'emploi page 29

Running a Preparation Method
Using a Specimen Mover plate
Using the Specimen Holder
Adjusting the Force
Adjusting the Preparation Time
Running the preparation
RotoForce-1
Instruction Manual
Quick Reference Card
n Move RotoForce-1 into the upright position.
−
Remove the three screws securing the mover plate or
slide the specimen holder of the legs.
−
Put a specimen mover plate in position and secure it with
the three screws.
−
Move RotoForce-1 into the upright position.
−
Remove the three screws securing the specimen mover
plate.
−
Slide the specimen holder evenly onto the three legs.
n Insert the correct preparation disc and press RotoForce-1
down into the correct position.
fO
n Press FORCE
value.
tO
n Press TIME
value.
n Adjust time and force on RotoForce-1.
n Set RotoForce-1 to Auto.
n Set Lupo to Auto if lubricant dosing is required.
s
n Press START
fN
or to adjust the force to the desired
tN
or to adjust the time to the desired
on RotoPol.
23