Automatic Switch-Off; Safety Switch-Off; Fault Overview / Fault Reports - Sentiotec WORLD OF WELLNESS wave.com4 Instructions De Montage Et Mode D'emploi

Installation instructions, only for experts

5.1. Automatic switch-off

For safety reasons, your Wave.com4 sauna control unit switches off automatically
as standard after 4 hours. The switch-off time can be programmed in accordance
with Point „Automatic switch-off" of these operating instructions.

5.2. Safety switch-off

Your Wave.com4 sauna control unit is equipped with a safety cut-out via a safety
temperature limiter. This safety device is located in the sensor casing of the heater
sensor which is located above the sauna heater. Should the sauna heater fail to
switch off after attaining the desired temperature due to a defect of any kind, the
safety temperature limiter automatically interrupts the electrical circuit at approx.
139 °C and switches the sauna heater off.
CAUTION!
Should a cut-out of this type occur, the safety temperature limiter must
be exchanged and an expert consulted under all circumstances.

6. Fault overview / fault reports

Your Wave.com4 sauna control unit is equipped with sophisticated diagnostic
software. The self-test is performed during control unit start-up. The system
statuses are verified both during this test and while using the sauna control unit.
As soon as the diagnostic software recognises a fault in the system, the Wave.
com4 sauna control unit switches off automatically. In this case, all operating
symbols of the operating unit flash and a fault number appears. The following
table gives information on possible faults and their cause if necessary.
TIP!
Inform service personnel of the fault notification. This can help to locate
the error and find a solution more quickly if necessary.
TIP!
In the event of a fault, a reboot may be useful and may rectify the fault.
To do this, disconnect the control unit from the mains at all poles (deac-
tivate main switch).
WORLD OF WELLNESS
p. 29/42
EN