Motor Overriding System; Installation Layout - V2 Gold400A Mode D'emploi

MOTOR OVERRIDING SYSTEM

In case of a blackout, the gate can be operated directly from the
motor. Insert the key supplied in the lock 1 on the front side of
the motor, perform 1/4 of a turn and open the plastic door
completely.
To restore the automation, simply close the door, rotate the key
in closed position and slide the specially provided plastic cover
onto the lock.
WARNING: ALL THE CABLES USED FOR THE INSTALLATION MUST BE MARKED WITH T100°C.
Power supply
Blinker
External Aerial
Digital or key selector

INSTALLATION LAYOUT

cable 3 x 1,5 mm 2
cable 2 x 1,5 mm 2
cable RG-58
cable 2 x 1 mm 2
WARNING: In case the leaf overruns its final position and
impacts against the safety stroke end (i.e. wrong regulation of
the limit switches),and a manual unclamp would be necessary,
before using the above procedure, you have to replace the leaf
setting away from the safety stroke end using the flat screw on
the main motor shaft 2 with a screwdriver.
Internal Photocellules
External Photocellules
Safety edge (EN 12978)
15
cable 4 x 1 mm 2 (RX)
cable 2 x 1 mm 2 (TX)
-