Input, Output And Control Section - dB Technologies Sigma S218 Caractéristiques Techniques

INPUT, OUTPUT AND CONTROL SECTION

2
1
1. BALANCED INPUTS
XLR (balanced) input connectors. They may be used for mono or stereo connection. For further details
concerning connection, refer to INPUT CONNECTIONS AND AUDIO DAISY CHAIN.
2. BALANCED OUTPUTS
XLR (balanced) output connectors. They may be used for mono or stereo connection. For further details
concerning connection, refer to INPUT CONNECTIONS AND AUDIO DAISY CHAIN.
3. SUBWOOFER LEVEL
Rotary switch to adjust output audio level.
4. XOVER / OUTPUTS MODE
Selector allowing to set the type of output signal (Link/Xover). It acts on the daisy-chained signal from
OUTPUT connectors [2].
5. SUBWOOFER SETUP (DELAY, POLARITY)
Buttons allowing to control (Normal or Reverse) Polarity and the type of output filtering (Flat, i.e. without
equalisation, Boosted, i.e. low frequencies are emphasised).
6. LED (Limiter, Signal/ON)
Indicator LEDs. The Limiter LED turns on when the internal protection circuit is triggered, while Signal/ON
indicates subwoofer power-up as well as the presence of an input audio signal.
7. SERVICE DATA
Mini-USB type-B port enables user to update product firmware. For further information, refer to FIRMWARE
UPDATES.
SIGMA S218
24
BALANCED
OUTPUTS
OUT 1 OUT 2
BALANCED
INPUTS
INPUT 1 INPUT 2
DELAY POLARITY
0
4.5 [ms]
0.5
4.0
1.0
SUBWOOFER
SETUP
1.5
3.5
3.0 2.0
2.5
5
120Hz
XOVER
90Hz
OUTPUTS
Link
MODE Xover
LIMITER
SIGNAL
MUTE/PROT
READY
SERVICE
DATA
SUBWOOFER
LEVEL
0dB
STEREO
0°
0dB
180°
MONO
3
English
4
6
7
Cod. 420120258 REV. 1.0