Klarstein Virtuosa EcoAdapt Mode D'emploi page 45

Connecting the Hob to the Mains Power Supply
WARNING
Risk of injury! This hob must be connected to the mains power supply
only by a suitably qualifi ed person.
The power supply should be connected in compliance with the relevant standard, or a
single-pole circuit breaker. The method of connection is shown below.
• If the cable is damaged or needs replacing, this should be done by an after-sales
technician using the proper tools, so as to avoid any accidents.
• If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3 mm between the contacts.
• The installer must ensure that the correct electrical connection has been made and
that it complies with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and only replaced by a proper qualifi ed
person.
EN
45