Bosch 0 607 460 001 Notice Originale page 16

OBJ_BUCH-2098-002.book Page 16 Wednesday, September 21, 2016 9:50 AM
16 | English
An exact estimation of the level of exposure to vibration
should also take into account the times when the pneumatic
tool is switched off or when it is running but not actually doing
the job. This may significantly reduce the exposure level over
the total working period.
Technical Data
Article number
No-load speed
Output power
Maximum torque
Max. screw diameter
Right/left rotation
Tool holder
Switch start
Lever start
Safety clutch
Engaging clutch
Max. working pressure for tool
Thread size of hose connection
Inner diameter of hose
Air consumption at no-load
Weight according to EPTA-Procedure
01:2014
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents:
EN ISO 11148 according to the provisions of the directive
2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch Power Tools GmbH, PT/ECS,
70538 Stuttgart, GERMANY
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ECS
Robert Bosch Power Tools GmbH
70538 Stuttgart, GERMANY
Stuttgart, 01.01.2017
1 609 92A 37V | (21.9.16)
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintaining the pneu-
matic tool and the accessories, keeping the hands warm, or-
ganisation of work patterns.
Pneumatic Torque Control Screwdriver
0 607 460 001 0 607 460 401
-1
min 900
W 380
Nm 1.5 –10.0 1.5 –10.0
mm M 6

mm 1/4"
–


–
bar 6.3
psi 91
G 1/4"
mm 10
l/s 14
cfm 29.7
kg 1.0
lbs 2.2
Assembly
Devices for Safe Handling
 If you want to operate the pneumatic tool in a suspen-
sion device or a clamping fixture, take care to fasten it
in the device/fixture first before connecting it to the air
supply. This measure prevents accidental starting of oper-
ation.
Make sure that the auxiliary handle or the clamping fixture
holds the pneumatic tool securely and firmly.
Do not overload the clamping area.
Suspension Device
0 607 460 001
With the utility clip 4, you can fasten the pneumatic tool to a
suspension device.
 Regularly check the condition of the utility clip and the
hook of the suspension device.
Auxiliary Handle
0 607 460 001
– Slide the auxiliary handle 9 onto the clamping area (collar)
8.
The auxiliary handle 9 can be set to any position for a secure
and low-fatigue working posture.
Pneumatic Driver Drill
0 607 460 400
750 750
320 320
1.5 –8.0
M 6 6.3
 
1/4" 1/4"
 
– –

–

–
6.3 6.3
91 91
G 1/4" G 1/4"
10 10
13 13.5
27.5 28.6
1.0 0.83
2.2 1.8
Bosch Power Tools