Black & Decker BM10E Manuel D'utilisation Et D'entretien page 4

HOW TO
CHECK THE
PRESSURE
INFLATING
DEFLATING
Before performing any maintenance operation on the inflation gun, disconnect it from the compressed air
supply and discharge any pressure remaining within.
NEVER allow the inflation gun to be serviced by personnel without adequate training and instruction.
NEVER use non-original spare parts for maintenance.
In order to guarantee inflation gun efficiency and correct operation, the Manufacturer's instructions for cleaning and routine
maintenance must be scrupulously followed.
N.B. Pay careful attention to avoid dropping the gauge or subjecting it to impact.
1. Whenever the inflation gun will not be used for an extended period of time, disconnect it from all power supplies.
2. Grease any parts that might undergo damage if allowed subjected to excessive drying.
3. When using the inflation gun again after extended inactivity, change the liners indicated in the spare parts list.
We recommend making the inflation gun completely inoperative when dismantling and placing it out of use.
The inflation gun's construction materials are completel rec clable but must be divided according to type
and eliminated using the respective collection centres.
 Tire pneumatic pressure is indicated by the motor vehicle manufacturer and varies by type.
 Carefully check the pressure to which the tire must be inflated indicated by the motor vehicle
manufacturer and/or the tire manufacturer. Incorrect inflation pressure can lead to the
explosion of the tire.
Insert the valve at the end of the hose into the tire's own inflation valve.
The pressure inside the tire is shown directly on the gauge.
If the tire pressure is lower than the value indicated by the motor vehicle manufacturer:
 Insert the valve at the end of the hose into the tire's own inflation valve
 Pull the gun lever at intervals to inflate the tire
 Read the tire's pressure on the gauge at the same time
 Continue inflating the tire to the required pressure in this way
 Detach the gun inflation valve from the tire's valve at the end
If the tire pressure is higher than the value indicated by the motor vehicle manufacturer:
 Insert the valve at the end of the hose into the tire's own inflation valve
 Lightly press either the black rubber-coated button or the lever at intervals to deflate the
tire.
 Read the tire's pressure on the gauge at the same time
 Continue inflating the tire to the required pressure in this way
 Detach the gun inflation valve from the tire's valve at the end
ORDINARY MAINTENANCE
PLACING THE GUN OUT OF USE
OPERATION
WARNING
WARNING
STORAGE