JVC RV-NB75B Instructions page 13

Sound mode
Sound modes can be selected to enhance the type
of music being played.
Press [SOUND MODE] to select the sound
mode.
Each time you press the button, the sound mode
changes as follows:
"BEAT" : Select this for music with a heavy
beat, such as rock and dance music.
"POP" : Select this for light music including
popular and vocal music.
"CLEAR" : Select this for crisp and clear
sounding music.
"USER" : Select this for music with the
configured treble and bass settings.
Refer to the following for the setting
procedures.
"FLAT" : Select this to cancel the sound
mode.
NOTE
The sound mode setting also affects the sound
0
through the headphones.
To set your preferred sound quality
Press [TREBLE+/-] or [BASS+/-] repeatedly.
Each time you press the button, the bass/treble can
be adjusted in the following ranges:
Treble : TREBLE -5 to TREBLE +5
Bass : BASS -5 to BASS +5
The sound mode switches to "USER" and the
0
sound quality is adjusted to the configured
values when the [TREBLE+/-] or [BASS+/-]
button is pressed.
/
Auto power save mode
This function turns off the System automatically if
no operation is performed for 15 minutes.
Each time you press [A.P.S.], the auto power save
function switches on and off.
A.P.S.
If no operation is performed for 15 minutes in the
following situations, the System turns off
automatically.
- The volume level is set to MIN or Muting is
activated.
- "CD" or "USB" is selected as the source, and
playback is stopped.
- "iPod", "BLUETOOTH" or "USB" is selected as
the source, and no device is connected.
- "AUDIO IN" is selected as the source, and there
is no sound input.
Approximately 30 seconds before the power is
0
turned off, "A.P.S." starts to blink.
The 15-minute countdown restarts when you
0
operate any buttons.
This function operates even during daily timer
0
and sleep timer operations.
This function is on at the initial setting.
Display information
Each time you press the button, the display
information switches depending on the source.
Tag information is shown on the display window
0
while an MP3/WMA file is played back.
If there is no tag information, "UNKNOWN" is
0
displayed.
"iPod" cannot show the track information.
0
13