Teka GZC Serie Manuel D'utilisation page 66

TYPE OF
HOT PLATE
Gas hot plate
ATTENTION!!!
If the power supply cable is replaced, the installer should leave the ground wire (B) longer than the
phase conductors (fig. 14) and comply with the recommendations given in paragraph 8.
WARNING: MAINTENANCE MUST ONLY BE
PERFORMED BY AUTHORISED PERSONS.
In case of failure or cut in the cable, please move away from
the cable and do not touch it. Moreover the device must be
unplugged and not switched on. Call the nearest authorized
service center to fix the problem.
SERVICING
CABLE TYPES AND SECTIONS
TYPE OF
CABLE
H05 RR - F
66
SINGLE - PHASE
POWER SUPPLY
2
Section 3 x 0.75 mm