Fault Indications; Causes And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN TC 2100 Manuel D'instructions D'origine

Attention
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

17.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Display Description
E05 Overheating Protection: This means that the temperature had increased to a
temperature of 270°C. In this case the device turns off automatically in order to
avoid damages.
In case of "E05" please pull the power plug in order to reset the device. After
this you can use it again as usual.
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.

17.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Display is empty
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not put your old
device into the non-recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Please note
Possible Cause
Power plug not plugged in
Fuse switch not switched on
Please note
Please note
To Rectify
Insert plug into mains socket
Switch on fuse switch
45