Dremel VersaTip 2000 Consignes De Sécurité/D'utilisation page 7

DM 2610Z06356 05-14 copy_2000 5/7/14 11:47 AM Page 7
To install the Deflector: Slide the Deflector
over the end of the Flame Diffuser until the
Deflector is firmly secured to the Flame
Diffuser. To remove, slide the Deflector off
the Flame Diffuser.
Lighting and Operation of the
Dremel VersaTip
The Dremel VersaTip igniter is equipped with
a safety mechanism intended to protect
against unintended ignition.
To ignite the VersaTip:
a. Turn the Flame Control Slider to the
minimum position,
b. Grasp the torch body placing your thumb
on the safety lock,
c. Using your thumb, rotate the Safety Lock
forward (Figure 6) and pull back the
Trigger (Figure 7),
d. Observe the Flame Guard to see if glow of
the flame is visible. Also, listen for a sound
of flame.
If there is no flame glow and the sound is
of the escaping gas, then release the
Trigger and repeat steps c and d. If ignition
occurs, continue to step e.
e. Once the torch is ignited, you can hold on
to the Trigger to maintain the flame, or slide
the Lock-On Button to the lock position for
continuous operation (Figure 8).
To turn off the Dremel VersaTip, let go of the
Trigger, and move the Lock-On Button to the
right if it was engaged during use. This will
immediately stop the flow of butane gas and
extinguish the torch flame.
Flame Length and Temperature
Adjustment of the flame length / temperature
can be made by adjusting the Flame Control
Slider. To increase flame length and
temperature, move the Flame Control Slider
to the right (+). To decrease flame length and
temperature, move the Flame Control Slider
to the left (-).
When using with any of the contact
attachments (Figure 2) allow 25 seconds for
tips to reach full temperature. When using
non-contact attachments (figure 2) the full
temperature is available immediately after
ignition.
Adjustment
FIG. 6
Flame
LOCK
Control
Slider
FIG. 7
LOCK
FIG. 8
Lock-On
Button
LOCK
-7-
Safety
lock
Trigger