Dremel VersaTip 2000 Consignes De Sécurité/D'utilisation page 6

DM 2610Z06356 05-14 copy_2000 5/7/14 11:47 AM Page 6
Observe
W RNING
warnings
instructions when using the torch.
In cold weather size of flame will be smaller.
To produce larger flame, pre-warm torch to
room temperature prior to use.
Ensure all accessories are securely tightened
before igniting the torch.
Familiarize yourself with the construction of
the Dremel VersaTip components (Figure 1),
and its accessories (Figure 2) before use.
Filling / Refilling Operation
Filling / refilling of the fuel tank must be done
in a well-ventilated place far away from any
possible sources of ignition. Be sure to
observe the safety instructions and warning
notices provided by the manufacturer of the
liquid butane fuel. Make sure the gas you are
using is a refined butane gas that can also
be used for lighters.
1. Hold the VersaTip with the Filling Valve
facing up, then invert fuel container and
insert the tip into the Filling Valve as
shown in Figure 3.
2. Push the fuel container and VersaTip
together to allow fuel to flow into the torch
fuel tank. The VersaTip fuel tank should be
filled in about 10 seconds.
3. Stop refilling once the fuel begins to
escape at the Filling Valve.
4. Wait at least 3 minutes to allow fuel gas to
stabilize before igniting the VersaTip.
Installing or Changing Tips
Use of the Soldering Tip, Cutting Knife,
Shaping Knife, Hot Air Tip, Wide Tip Blower,
and Deflector requires the Flame Diffuser to
be installed.
To install the Flame Diffuser: Unscrew the
Flame Guard nut and remove the Flame
Guard. Slide the Flame Diffuser into the
Flame Guard by inserting the narrow end of
the Flame Diffuser into the Flame Guard first.
Figure 4 shows correct assembly of the
Flame Diffuser. Place the Flame Guard with
Flame Diffuser back on to the tool and
securely tighten the Flame Guard nut.
To install threaded attachment tips:
Thread the desired tip into the Flame Diffuser
and tighten using the 7mm wrench while
Operating Instructions
all provided
and safety
FIG. 3
FIG. 4
FIG. 5
using the 8mm wrench to hold the Flame
Diffuser in place, Figure 5. To remove follow
the installation steps in reverse order.
To install the Wide Tip Blower: Slide the
Wide Tip Blower over the Flame Diffuser and
Flame Guard until the Wide Tip Blower is
firmly secured to the Flame Guard. Make
sure there is no tip installed in the Flame
Diffuser before installing the Wide Tip
Blower. To remove, slide the Wide Tip
Blower off the Flame Guard and Flame
Diffuser.
-6-
Filling
Valve
Flame
Guard
7mm Wrench 8mm Wrench
Flame
Diffuser