Publicité
Les langues disponibles
Les langues disponibles
2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 19
DRILLING WOOD OR PLASTIC
Do not drill into wood with dust extraction
system mounted. Wood chips are typically too
large and will clog the dust channel.
pressure just before the bit breaks through
the wood to avoid splintering. Complete the
hole from the opposite side immediately after
the point breaks through. If bit binds, reverse
the drilling operation to help remove the bit
from the work.
orized per so n nel may result in misplacing
of internal wires and components which
could
cause
recommend that all tool service be performed
by a Bosch Factory Service Center or Autho -
rized Bosch Service Station.
Cleaning
tool from the power supply before
cleaning or performing any main tenance.
Tool Tips
If backing block is not
used, ease up on the
Maintenance
Service
Preventive maintenance
performed by unauth-
serious
hazard.
To
avoid
accidents
always dis connect the
DRILLING METAL
system mounted. Hot metal chips can self-
ignite or ignite parts of the dust extraction
system.
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety gog gles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
We
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents,
ammonia
detergents that contain ammonia.
-19-
Do not drill into metal
with the dust extraction
Certain cleaning agents
and sol vents damage
and
house hold
Publicité
