Description Of The Connections - Nice Wil Instructions Et Recommandations Pour L'installateur

3.3) Description of the connections

Here is a brief description of the possible connections of the unit to the outside:
FCA
FCC
3
Secondary of the power transformer
1-2 : 230 V a.c.
3-4 : Flashing light
5-6 : 24 V d.c.
7 : Common
8 : Courtesy Light
9 : C.A. Indicator
10 : Stop
11 : Photocell
12 : Photocell2
13 : Step-by-Step
14 : Open-Timer
15 : Close
: Aerial
The remaining connections are done in the factory but for the sake of completeness here is the list:
TRANS.PRIM.
TRANS.SECOND.
MOTOR
There are an additional two slots for optional cards:
RADIO
CHARGE
OK
Primary of the power transformer
= 230 V a.c. 50/60 Hz
= Output for connection to the 24 V d.c. flashing light, maximum lamp power: 25 W
= 24 V d.c. output for supplying accessories (Photocell, Radio, etc.) maximum 200 mA
= Common for all inputs (terminal 6 can also be used as the Common)
= 24 V d.c. output for the courtesy light, maximum output power 10 W
= Input with STOP function (Emergency, shutdown or extreme safety)
= Input for safety devices (Photocells, pneumatic edges)
= Input for safety devices with triggering in the opening phase (Photocells, pneumatic edges)
= Input for safety devices with triggering
= Input for cyclic functioning (OPEN STOP CLOSE STOP)
= Input for opening (which can be timer controlled)
= Input for closing
= Input for the radio receiver aerial
= Primary of the power transformer
= Secondary of the power transformer
= Output for 24 V d.c. motor connection
= Slot for Nice radio receivers
= Slot for battery charge card
Aerial
Close
Open-Timer
Step-by-Step
Photocell2
Photocell
Stop
C.A. Indicator
Courtesy Light
Common
24 Vdc
max 200 mA
Flashing light 24 Vdc
max 25 W
230 Vac
50-60 Hz
GB
7