Ottobock 1H38 Instructions D'utilisation page 10

1.1 Construction and Function
The 1H38 and 1H40 single axis prosthetic feet are suitable for use in both
modular and exoskeletal prostheses. The functional properties are achieved
through the combination of a contoured core and functional foam.
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of modular
connectors. Functionality with components of other manufacturers that have
compatible modular connectors has not been tested.
2 Intended use
2.1 Indications for use
The product is intended exclusively for lower limb exoprosthetic fittings.
The product is suitable for fittings of geriatric patients.
2.2 Area of application
Our components perform optimally when paired with appropriate compon­
ents based upon weight and mobility grades identifiable by our MOBIS clas­
sification information and which have appropriate modular connectors.
The product is recommended for mobility grade 1 (indoor walk­
er).
m°
kg
The product must be used in TF prostheses only.
• The maximum approved body weight is specified in the technical data
(see page 15).
• The bilateral use of 1H* prosthetic feet imposes stricter requirements for
the user's balance.
2.3 Environmental conditions
Allowable environmental conditions
Temperature range for use: -10 °C to +60°C
Allowable relative humidity 0 % to 90 %, non-condensing
Unallowable environmental conditions
Mechanical vibrations or impacts
Perspiration, urine, fresh water, salt water, acids
Dust, sand, highly hygroscopic particles (e.g. talcum)
Other environmental conditions
UV light
10
Not resistant