Publicité
Les langues disponibles
Les langues disponibles
Connecting the lock lever
For simultaneous triggering of the two 17Y57 lock levers, the lock levers can
be interconnected.
1) Weld or solder the 17Y53 connection tube to the lock lever.
2) Verify that the two locks release and engage simultaneously.
3) Connect the lock levers with a traction element (e.g. elastic strap) to
enable engaging.
Using protective devices
► Protect the product against dirt: Use suitable protective devices
(e.g. joint protectors).
6 Cleaning
Promptly clean the product after contact with water containing salt, chlorine
or soap, or if it gets dirty.
1) Rinse system joints with clean fresh water.
2) Dry system joints with a cloth or allow to air dry. Avoid exposure to direct
heat (e.g. from an oven or radiator).
7 Maintenance
CAUTION
Use of an incorrect lock
Injuries from falling due to an incorrect lock being installed
► Only use locks of the same size when reinstalling or replacing.
INFORMATION
The product may be exposed to increased loads by the patient.
► Shorten the maintenance intervals according to the expected loads.
INFORMATION
Increased wear and tear
The orthotic knee joints are intended only for use in combination with free-
motion or foot lifting orthotic ankle joints. Wear occurs more rapidly in
combinations involving orthotic ankle joints with a dorsal stop.
The manufacturer requires at least a semi-annual inspection of the product
to verify functionality and check for wear.
Spare parts are listed in the section "Components/design".
Only use 633F7 special lubricant.
16
Publicité
