Ottobock 17B66 16 Instructions D'utilisation page 12

The following combinations are possible:
Combination
Installation
position
anterior
Stop pin
Spring
Spring stop
Spring
Stop pin
Spring stop
Spring
Stop pin
Spring stop
► Install the bearing ball (5), stop pins (6) and spring (7) with the set
screws (1) in the combination required. Use Loctite® 241 to secure the
set screws (1).
6 Cleaning
After contact with water containing salt, chlorine or soap, or when they get
dirty, the system joints must be cleaned promptly.
1) Rinse the system joints with clean fresh water.
2) Dry the system joints with a cloth or allow to air dry. Avoid exposure to
direct heat (e.g. from an oven or radiator).
12 | Ottobock
Installation
position
posterior
Stop pin
Stop pin
Spring
Spring
Spring stop
Spring stop
Application
e.g. ICP or spina bifida
e.g. in case of distinct hyperextension in
the knee joint
e.g. with distinct hyperextension in the
knee joint, but with additionally
adjustable damped dorsal stop
e.g. in case of weakness of the lower leg
muscles
Dorsiflexion assist, e.g. in case of
peroneal paralysis without own muscular
knee joint protection
e.g. in case of pareses of the lower leg
muscles
e.g. in case of weakness of the lower leg
muscles with tendency to hyperextension
of the knee joint
Dorsiflexion assist, e.g. in case of
pareses of the lower leg muscles without
muscular knee joint protection
e.g. in case of pareses in the lower leg
muscles with weakness of the knee-pro­
tecting muscles