Jacuzzi Designer Directives D'installation & D'utilisation page 4

Important: Read complete instructions before beginning installation.
Each whirlpool bath arrives ready for installation, completely equipped with motor/pump assembly and plumbing and fittings necessary for
whirlpool operation. An optional drain/overflow kit is available for installation on the bath.
Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been made. Do not lift the bath
by the plumbing at any time; handle by the shell only.
Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect in the finish, do not install the
bath. Damage or defect to the finish claimed after the bath is installed is excluded from the warranty. Jacuzzi Whirlpool Bath's responsibility for
shipping damage ceases upon delivery of the products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of
warranty coverage and limitations, refer to the published warranty information packed with the product.
All bath units are factory tested for proper operation and watertight connections prior to shipping. Note: Prior to installation, the bath must
be filled with water and operated to check for leaks that may have resulted from shipping damage or mishandling. Jacuzzi Whirlpool
Bath is not responsible for any defect that could have been discovered, repaired, or avoided by following this inspection and testing procedure.
L
SIDE VIEW
L
H
SIDE VIEW
AURA
1" (25.4 mm) FLANGE
L
SIDE VIEW
L
SIDE VIEW
PULSAR
1" (25.4 mm) FLANGE
L
SIDE VIEW
W
51 mm
2"
H
END VIEW
W
2-3/4"
70 mm
END VIEW
W1
W
2"
H
51 mm
END VIEW
MERANO
2"
W
51 mm
1"
H
25.4 mm
END VIEW
W1
2"
W
51 mm
H
END VIEW
SIENA
A
DRAIN/OVERFLOW
L
SIDE VIEW
L
SIDE VIEW
L
H
SIDE VIEW
L
H1
H2
2"
51 mm
SIDE VIEW
TORRETTA 36 & TORRETTA 42
2
B
70 mm
W
2-3/4"
H1
END VIEW
FONTANA
W
2''
51 mm
END VIEW
MIRA
W
51 mm
2"
END VIEW
SABELLA
W
H3
END VIEW
H2
H
25.4 mm
1"