Jacuzzi Designer Directives D'installation & D'utilisation page 18

Electronic Control Panel Operation
General Functions
The bath is equipped with a water level sensor. When the water level
is below the sensor, the pump/motor can not be activated. If the ON/
Off pump/motor button is pressed at this time, the display will show
"LO" for 5 seconds and the low level indicator will come on. When the
water goes above the level sensor, the low water level indicator will
go off and the pump/motor can then be activated. If the water level
drops below the level sensor, the pump/motor will shut off. To restart
the pump/motor after the water level goes above the level sensor, the
ON/OFF button must be pressed. The pump/motor will automatically
shut off 30 minutes after the pump/motor was turned on.
Note: Depending on the mineral content in your water, which affects
the conductivity of the sensing feature, your water level sensing may
not operate properly. If this occurs, please contact customer service
for a bypass which will allow you to use the bath without the water
level sensor feature.
Normal Operation
(with the bath filled to the proper
level)
On/Off Pump/Motor
Pressing this button will turn on the pump/motor. Pressing a second
time will turn off the pump/motor.
#1 Air Flow Increase
Pressing this button will increase air flow to one set of jets. The air
flow can be adjusted from no air to maximum air. The display will
show up to four bubble icons flashing on and off. Each additional
icon indicates more air flow.
LED DISPLAY
#1 AIR FLOW INCREASE
LOW WATER
LEVEL INDICATOR
#1 AIR FLOW DECREASE
BUBBLE ICONS
#1 Air Flow Decrease
Pressing this button will decrease air flow from the one set of jets.
The air flow can be adjusted from maximum air to no air. The display
will show fewer bubble icons flashing on and off indicating less air
flow. No flashing icon indicates that the air has been turned off.
#2 Air Flow Increase
Pressing this button will have the same effect as #1 Air Flow Increase
for the other set of jets.
#2 Air Flow Decrease
Pressing this button will be the same as #1 Air Flow Decrease for the
other set of jets.
WaveFlow ™
Pressing this button will first turn off air to both sets of jets followed by
on and off air supply to first one side of the bath and then to the other
side. This will continue until the wave button is pushed a second
time, which stops the wave action.
Temperature
Pressing this button will display the water temperature (or air tem-
perature if the bath is empty).
Bath Ligh
Pressing this button will turn on the bath light(s). Pressing a second
time will turn the light(s) off.
TEMPERATURE
WAVEFLOW
ON/OFF PUMP MOTOR
BATH LIGHT
16
#2 AIR FLOW
INCREASE
#2 AIR FLOW
DECREASE