Camera Positions; Close-Up Viewing - Optelec MultiView Manuel De L'utilisation

Optelec MultiView
270 degrees tilt
Note: Do not force the camera head beyond its limit as this could permanently
damage the rotation axis feature.
The camera arm can be moved from left to right, and right to left, by using the
slider located at the back of the base stand. The following figure shows the
slider.

Camera positions

The MultiView automatically returns to its original settings when the camera is
switched from close-up to distance viewing and vice-versa. For example,
when the camera is tilted quickly from the whiteboard you are viewing to the
top of your desk, your preferred viewing mode and magnification settings will
automatically be applied. Three setting options can be stored: close-up
viewing, self-viewing and distance viewing.

Close-up viewing

To view objects placed on a table, or to write under the camera, point the
camera head toward the top of the desk and position the close-up lens in front
of the camera. The recommended distance for close-up viewing is between 30
and 40 cm (12 and 16 inches).
English Page 10