Getting To Know Your Multiview; Setting Up The Multiview - Optelec MultiView Manuel De L'utilisation

Optelec

4. Getting to Know Your MultiView

The following figure shows the MultiView's main components.
1. Base stand
2. 19" wide screen display
3. Handle
4. Camera arm
5. Camera connection point
6. Camera head

Setting up the MultiView

To set up the MultiView, please follow the steps described below:
− Install the camera head:
- Attach the camera head to the camera arm by fastening the screw
at the camera connection point.
- Connect the data cable to the data cable connector located in back
of the camera head.
− Connect the control pad in the USB port located on the left side of the
base stand.
− Connect the power cable in the power connector located on the right
side of the base stand.
− Plug the other end of the power cable into an electrical power outlet.
English
7. Control pad
8. X-Y reading table
9. Handle of X-Y reading table
10. Camera rotation axis
11. Slide track
12. Reading table support
MultiView
Page 8