Creating The Best Listening Space; Placing The Speakers (Nx-P200); Placing The Center Speaker; Placing The Subwoofer - Yamaha DVX-S200 Mode D'emploi

Creating the Best Listening Space

Placing the Speakers (NX-P200)

Placing the Center Speaker

Peel off
the seal

Placing the Subwoofer

54
To get the most out of the sound field effects you need to place the speakers
in the best positions. To guard against poor acoustics like sound blur make
sure the speakers are stable. Also read page 7, "Preparing the Speakers".
Make sure the top of the television is level. If the top of the
television is not level, place the Center Speaker inside the
TV rack or directly on the floor. In any case, make sure it is
placed on a level surface.
When placing on top of the television, use the supplied
fastener (two pieces) as shown in the picture on the left,
between the bottom of the Center Speaker and top of the
television to fasten.
Fastener
Notes
• Do not place on a television with top narrower than the bottom of the
speaker. You may get injured if the speaker falls over.
• Do not place if the top of the television is slanting. You may get
injured if the speaker falls over.
• After peeling off the fastener seal, do not touch the bonding surface. If
you do, the bonding surface weakens, which later may cause the
speaker to fall over.
• Before attaching the fastener to the television, wipe the TV top clean.
If the surface is dirty or wet tape will lose bonding strength, which
later may cause the speaker to fall over.
Place the Subwoofer on a level hard floor.
Use non-skid pads on the bottom of the Subwoofer in the
four corners as shown in the picture. This will prevent the
Subwoofer from sliding when it vibrates and increase
stability, preventing degradation of sound.