Publicité
Les langues disponibles
Les langues disponibles
Cleaning hatches.
5.5.
Cleaning of the gas outlet circuit. Always with the boiler disconnected. (Very important).
For an optimal cleaning of the extractor's collector, it is recommended to dismantle the extractor itself in
order to have full access to this zone for a better cleaning. Once the extractor is dismantled, clean it with a
dry brush and be careful with the turbine and structure.
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.
Exhaust circuit extractor.
Ceramic fiber joint (replace).
5.6.
Dismantling and cleaning of gas outlet pipes.
When mounting the gas outlet pipeline, make sure it is well assembled, preferably sealed with silicone. If the
pipe has sealing joints, you must verify its good condition and replace it if necessary.
5.7.
Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.
5.8.
Review the fireplace door joints.
Review in detail any imperfections which may cause an air inlet. Replace them if necessary.
5.9.
Cleaning of dirt which may be accumulated on the inside of the boiler (lower part, components, etc.). You
can access to it by the rear of thereof.
5.10. Cleaning of the pellets drop tube.
Use the brush provided by ECOFOREST to remove the dust until the end of the tube.
41
Drawing 20
Drawing 21
Publicité
