ECOFOREST VAP 30 Manuel D'installation Et Maintenance page 137

CONTROL OF THE REVISIONS AND ANNUAL MAINTENANCE.
In order to optimize the functioning of your boiler ECOFOREST it is necessary to carry out the operations of
maintenance detailed in chapter 5 of the instructions manual. Those that shall be done annually must be carried out
by an authorized technician. Contact your distributor so that he sends you the qualified personnel required. Consider
than in order not to lose the warranty of your boiler, you must carry out this annual maintenance and for it to
remain valid, the technician who carries it out must fill in, sign (or stamp) the following forms:
Name of technician:
Date:
Clean fireplace.
Dismantle extractor and clean collector of gas outlet.
Clean gas outlet extractor.
Replace extractor joints, both from socket and motor.
Clean gas outlet pipe and check it is in perfect condition
Make sure the burn pot isn't bended nor broken.
Check ashtray's and door's joint.
Remove and clean smoke ways and turbulators
Lubricate moving parts.
After cleaning, make sure the boiler operates correctly.
If everything works properly, disconnect the boiler until
next use.
Stamp or signature:
Name of technician:
Date:
Clean fireplace.
Dismantle extractor and clean collector of gas outlet.
Clean gas outlet extractor.
Replace extractor joints, both from socket and motor.
Clean gas outlet pipe and check it is in perfect condition
Make sure the burn pot isn't bended nor broken.
Check ashtray's and door's joint.
Remove and clean smoke ways and turbulators
Lubricate moving parts.
After cleaning, make sure the boiler operates correctly.
If everything works properly, disconnect the boiler until
next use.
Stamp or signature:
Name of technician:
Date:
Clean fireplace.
Dismantle extractor and clean collector of gas outlet.
Clean gas outlet extractor.
Replace extractor joints, both from socket and motor.
Clean gas outlet pipe and check it is in perfect condition
Make sure the burn pot isn't bended nor broken.
Check ashtray's and door's joint.
Remove and clean smoke ways and turbulators
Lubricate moving parts.
After cleaning, make sure the boiler operates correctly.
If everything works properly, disconnect the boiler until
next use.
Stamp or signature:
Name of technician:
Date:
Clean fireplace.
Dismantle extractor and clean collector of gas outlet.
Clean gas outlet extractor.
Replace extractor joints, both from socket and motor.
Clean gas outlet pipe and check it is in perfect condition
Make sure the burn pot isn't bended nor broken.
Check ashtray's and door's joint.
Remove and clean smoke ways and turbulators
Lubricate moving parts.
After cleaning, make sure the boiler operates correctly.
If everything works properly, disconnect the boiler until
next use.
Stamp or signature:
136