Temp Function; Lock Function; C O °F Using Function; I Feel" Function - emmeti XECO Serie Manuel D'installation

8. AIR CONDITIONER USE

8.13 TEMP function

When this key is pressed, the following symbols
appear on the remote control.
- The set temperature will be displayed when the symbol
- The room temperature is displayed when the symbol
seconds).
- The set temperature will be displayed when the symbol
- The set temperature will be displayed when no symbol appears.

8.14 LOCK function

+ –
Press the and keys at the same time to lock or unlock the remote control
keypad.
If the remote control is locked, the icon
To check that the keypad is locked, press any key, the icon
times.
If the keypad is unlocked the icon
8.15 °C o °F using function
When the indoor unit is off, press the "MODE" and "
time. The display will show the temperature in °C or in °F.
8.16 " I FEEL " function
The remote control has a probe that measures the ambient temperature
and once this function is activated, the remote control will send a signal
to the air conditioner card every 10 minutes with the measured tem-
perature, preventing air stratification especially in heating mode. It is
updated also by pressing any other key on the remote control.
(Remove all obstacles between the remote control and the internal unit
receiver)
To activate the " I Feel " function, press the I FEEL key.
the symbol will appear on the display
To deactivate the " I Feel " function, press the I FEEL key again.

8 .17 HEALT function

The internal unit is equipped with a negative ions generator to purify
the air.
To enable HEALTH function please push the relevant button,
the icon will appear on display.
To disable HEALT function please press the relevant button again
70
➞ OFF
➞ ➞
appears.
appears (5
appears.
appears on the display.
will flash 3
will not appear.
-
" keys at the same
GB GB