Using The Surface Brush On Wood Surfaces; Using And Replacing The Joint Brush; User Information; Replacing The Joint Brush - Gloria MultiBrush Mode D'emploi

6.1.4 Using the surface brush
on wood surfaces (optionally
available as an accessory)
ATTENTION! Improper use of the
device poses a risk of damage to
property! You should therefore
observe the following safety
instructions:
Never use the hard surface brush
with the black bristles for cleaning
wood surfaces, as the hard bristles
attack the surface of the wood,
thereby damaging it.
NOTE!
For cleaning wood surfaces use the
soft surface brush with the yel-
low/black bristles. This is available as
a GLORIA accessory and is not in -
cluded in the scope of delivery.
Assembly and operating instructions
can be found in the product informa-
tion "Surface brush for wood
surfaces".
6.1.5 Using and replacing the
joint brush
Figures 20 - 22
Assemble the joint brush as described
20
in Chapter 6.1.2. Place the device
parallel with guiding wheel and joint
brush on the joint to be treated. Hold
the device at working angle and make
sure that the rubber lip on the safety
guard (H) is just above the ground.
NOTE!
To adjust the safety guard (H), turn
21
the 7 click-stop safety guard to the
position described under point "20"
above.
Align the joint brush with the centre
22
of the joint, walk at an even steady
pace and push the device in front of
you. Adapt your pace of work to the
degree of soiling.
NOTE!
Always work along the joint and hold
the device away from your body.
In cases of stubborn dirt you can
move the device backwards and for-
wards on the spot (like a scrubber),
until the required result is achieved.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!

6.2 User information

Do not remove any wet weeds with
the device.
Never clean wood decks or wood ter-
races with the joint brush.
Only clean joints that are intact.
Damaged or crumbling joints or
joints with cracks should not be
cleaned with the device.
Rinse the cleaned surfaces tho-
roughly after cleaning.
Worn brushes i.e. frayed bristles
should be replaced in good time.
Switch off the device, before starting
with the next cleaning course (e.g.
wood decks).

6.3 Replacing the joint brush

Figures 23 - 26
Switch off the device and disconnect
the power cord (C) from the power
supply.
Open the locking device (K)
23
the joint brush unit (J), as shown in
the illustration, and remove the joint
brush unit.
28
of