Using The Surface Brush On Rough Surface Structures - Gloria MultiBrush Mode D'emploi

Masquer les pouces Voir aussi pour MultiBrush:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Disassembly of joint brush followed by
assembly of the surface brush
Dismantle the joint brush according
to handling and function described
above.
Open the locking device (K)
15
drive arm (P) and, with the lock
applied, (K) put the drive arm (P) with
safety guard (O), onto the drive side of
the motor/gear unit (L), as illustrated.
Release the spring-loaded lock (K),
the drive arm is locked when the
locking device independently returns
to its original position
NOTE!
If the drive unit (P) cannot be pushed
15
onto the drive shaft, reach under the
safety guard (O) and turn the hexagonal
drive until the drive unit (P) slides onto
the drive shaft easily and without force.
Put the surface brush (N) onto the
16
hexagonal drive and then the guide
arm (M), as illustrated, on the steering
side of the motor/gear unit (L).
Now slide the lock (K) into open posi-
17
tion
, hold this and press the guide
arm (M) further onto the coupling
shaft up to the stop. Release the
spring-loaded locking device (K). The
guide arm (M) is locked when the
locking device independently returns
to its original position
NOTE!
Whilst assembling the surface brush,
18
make sure that the side part of the
safety guard on guide arm (M) is firmly
connected to the safety guard and is
correctly sealed.
of the
Figure 19
19
.
.
27
6.1.3 Using the surface brush on
rough surface structures e.g. tiles,
paving slabs, exposed aggregate
concrete, stoneware etc.
Place the switched-on device parallel on
the surface to be treated. Hold the device
at working angle and make sure that the
rubber lip on the safety guard is just
above the ground. Walk at an even steady
pace and push the device in front of you.
Depending on the degree of soiling, apply
light to medium pressure on the surface
brush, adapt your pace of work to the
degree of soiling.
NOTE!
Always work parallel and hold the
device away from your body.
When working close to edges, the
narrower side of the device should
point towards the wall.
In cases of stubborn dirt
you can move the device backwards
and forwards on the spot (like a
scrubber), until the required result
is achieved.
Moist cleaning is also possible in
cases of heavy soiling. Use a sprayer
to moist the surface to be cleaned
with water or a cleaning agent, a
GLORIA sprayer is ideal for this pur-
pose. After moit cleaning rinse the
surface with water.
CAUTION! RISK OF INJURY FROM
RUNNING BRUSHING TOOL!
Never lift the device off the ground
whilst switched on during work as
there is danger of entanglement!

Publicité

Table des Matières
loading

Table des Matières