Install Duct Covers - Thermador Masterpiece Serie Instructions D'installation

• Use UL listed wire connectors and connect black wires
(C) together.
• Use UL listed wire connectors and connect white wires
(E) together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box. Failure to do so can result in death or
electrical shock.
• Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (F) in terminal box
using UL listed wire connectors.
• Tighten strain relief screw.
• Install terminal box cover.
• Reconnect power.

Install duct covers

• When using both upper and lower vent covers, push
lower cover down onto hood and lift upper cover to
ceiling and install with two mounting screws.
NOTE: For vented installations, the upper vent cover
may be reversed to hide slots.
1. Insert the complete duct cover at an angle and swivel
toward the wall.
English | 16 |
2. Carefully pull the top part of the extension upwards.
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
3. From inside of hood, screw the supplied
sheet metal screws through the holes on each side
and along the front into bottom of the extension.
Screw quantity is dependent on hood size.
⁄ '' (16 mm)
5
8
Installation Instructions