Information For Your Safety - Kettler Marathon TX1 Mode D'emploi

GB
Functions and operation of the TX1 training computer

Information for your safety:

• In order to avoid injury due to stress or overload, the training unit may only be used as directed.
• Before first use and also after approx. 6 days of operation, the connections must be checked for tightness.
• Verify the operability and proper condition of the training unit at regular intervals.
• Safety inspections count among the operator's obligations and must be performed correctly and at regular intervals.
• The level of safety of the unit can only be ensured under the condition that it is regularly checked for damage and wear.
• Defect or damaged components must be replaced immediately. Only qualified persons may make modifications to the electrical
components. Only use original KETTLER replacement parts.
• The unit may not be used until corrective maintenance is complete.
• Before commencing training, check with your physician to make sure you are in fit health for training with this unit. The medical
results should be the basis for the configuration of your training program. Incorrect or excessive training can damage your health.
• The treadmill may only be used for its intended purpose, i.e. for running and walking training by adults.
• Fasten the cord of the safety switch to your clothing. Adjust the cord length: the switch should be triggered if you "stumble".
• For the first training units, familiarise yourself with the exercise sequences at low speed.
• Before commencing training, stand on the two side platforms, ready to run.
• If you ever feel uncertain, hold firmly onto the handrails and leave the belt by standing on the side platforms and pull out the safe-
ty key.
• Pulling out the safety key immediately switches off the belt operation and height adjustment!
• Unsupervised use of the treadmill by third parties can be prevented by removing and safekeeping the safety key. Always keep the
safety key in a safe place and prevent children from getting to the key!
Important: Also observe the safety notes given in the assembly instructions.
A B C D E F GH I J K
A TIME - Displays training time
C CAL - Displays calories
PULSE - Displays pulse rate
E STEIGUNG / INCLINE (+) - Increase incline
STEIGUNG / INCLINE (-) - Decrease incline^
G PROGRAM - Program selection
RECOVERY - starts the fitness score calculation
I COOL DOWN - starts cool down in run mode
K SPEED (+) - Increase speed
SPEED (-) - Decrease speed
M SPEED –- Display for speed
O SERVICE –- Treadmill must be serviced
8
M NO P
B CAL / PULSE – Display for calories or pulse
D STEIGUNG / INCLINE –Display for incline angle
F START - Starts the treadmill
ENTER - Confirms the input
H Switches between automatic and manual alternation of
CAL /PULSE display
J PAUSE - Press once to pause
STOP - Press twice to stop
L SAFETY KEY - Safety key switch
N km/h / km - Display is in metric units
meile / mph- Display is in Imperial units
P DISTANCE - Display for training distance