BE 66DX40GG1 Mode D'emploi page 8

The following diagrams are intended for general reference.
Your pressure washer may differ from the models shown in
the following pages. For specific model information, please
visit www.bepowerequipment.com
1.
2.
3.
4.
5.
6.
7.
1. Spray Gun - Controls the application of water onto cleaning surface with trigger
device. Includes trigger lock. Allows you to switch between various spray tips.
2. High Pressure Hose - Designed to withstand the pressure created by the pump.
3. Air Filter - Protects the engine by filtering dust and debris out of intake air.
4. Fuel Tank - FIll tank with regular, unleaded fuel. Always leave room for fuel expansion.
5. (Top) Choke Rod - Prepares a cold engine for starting.
(Bottom) Throttle Lever - Sets engine in starting mode for recoil starter.
6. Recoil Starter - Used for starting the engine manually.
7. Soap Tank - (Not included on all models) Fill with pressure washer detergent only.
8. Pump - Develops high pressure. Connect the garden hose to the inlet of the water
pump, and connect the high-pressure hose to the outlet. Connections vary by model.
9. Muffler/Exhaust - Reduces noise of the engine and expels heat.
10. Detergent Siphoning Hose - Used to draw detergent into the low pressure stream.
11. Spray Tips - Detergent, 0°, 15°, and 40°: for various cleaning applications.
14
GAS WASHER COMPONENTS
9.
8.
WWW.BEPOWEREQUIPMENT.COM
GAS WASHER COMPONENTS
7.
8.
11.
9.
10.
11.
10.
12.
13.
1. Spray Gun Controls the application of water onto cleaning surface with trigger
device. Includes trigger lock. Allows you to switch between various spray tips.
2. Spray Tips Detergent, 0°, 15°, and 40°: for various high pressure cleaning
applications.
3. High Pressure Hose Designed to withstand the pressure generated by the pump.
4. Unloader Pressure is preset at the factory.
5. Pump Develops high pressure. Connect the garden hose to the inlet of the water
pump, and connect the high-pressure hose to the outlet.
6. Oil Level Indicator Level should be at halfway (not included for all models).
7. Detergent Siphoning Hose Use to siphon pressure washer safe detergent into the
low pressure stream.
8. Fuel Tank Fill tank with regular unleaded fuel. Always leave room for fuel expansion.
9. Air Filter Protects engine by filtering dust and debris out of intake air.
10. Throttle Lever Sets engine in starting mode for recoil starter.
11. (Top) Choke Lever Prepares a cold engine for starting.
(Bottom) Fuel Valve Used to turn fuel supply on and off to engine.
12. Recoil Starter Used for starting the engine manually.
13. Engine Switch Set switch to "On" for recoil starting. Set switch to "Off" to stop a
running engine.
WWW.BEPOWEREQUIPMENT.COM
1.
2.
4.
5.
6.
3.
15