Starting Your Washer; How To Start Your Pressure Washer - BE 66DX40GG1 Mode D'emploi

How to Start Your Pressure Washer

To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also applies if you
have let the pressure washer sit idle for at least a day.
1. Place pressure washer near an outside water source capable of
supplying water at a flow rate at least 1 GPM greater than the
rated flow of your pressure washer. It should also be no less than
20 PSI at pressure washer end of garden hose. DO NOT siphon
standing water.
2. Make sure unit is in a level position.
3. Connect garden hose to water inlet on pressure washer pump.
NOTICE
DO NOT run the pump without the water supply connected and
turned on.
• Damage to equipment resulting from failure to follow this instruction
will void warranty.
4. Attach wand extension to spray gun. Tighten by hand.
5. Choose desired spray tip, pull back nozzle extension collar, insert
spray tip and release collar. Tug on spray tip to make sure it is
securely in place. See Spray Tips.
20

STARTING YOUR WASHER

WWW.BEPOWEREQUIPMENT.COM
STARTING YOUR WASHER
6. If your gun uses a quick-connect, pull down on the collar of the
quick connect coupler, slide onto the gun and let go of collar. Pull
on hose to ensure the connection is tight. If your gun uses an M22
fitting, simply thread the connections together until secure.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose directly to nozzle extension.
• Keep high pressure hose connected to pump and spray gun while
system is pressurized.
7. Attach the other end of the high pressure hose to high pressure
outlet (A) on pump. Pull down on collar of quick connect, slide
onto pump and let go of collar. Note that some pumps require
the hose to be threaded on. Tug on the hose to ensure connection
is secure.
A
B
axial pump
*Pump Uses SAE30 Non-Detergent Mineral Oil
8. Turn Water Supply on if you have not already done so. Point the
gun in a safe direction and squeeze the trigger to purge the pump
of air and debris. Do this until water flow is no longer erratic.
9. Take a final look at all connections to make sure there are no leaks
or loose connections. If there are any leaks in hoses, they must be
replaced.
IMPORTANT: DO NOT siphon standing water for the water supply.
Use COLD WATER only (less than 100°F/38°C). Hot water will damage
seals and compromise the integrity of your pump.
WWW.BEPOWEREQUIPMENT.COM
A
B
triplex pump
21