Important Warnings - BE 66DX40GG1 Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING – When using this product, the following precautions
should always be observed and adhered to.
1. Read all instructions before using the product.
2. To reduce the risk of injury, close supervision is necessary when a
product is used near children.
3. Know how to stop the product and bleed pressures quickly. Be
thoroughly familiar with the controls. See page 24.
4. Stay alert – watch what you are doing.
5. Do not operate the product when fatigued or under the influence of
alcohol or drugs.
6. Keep operating area clear of other people.
7. Do not overreach or stand on unstable support. Keep solid
footing and balance at all times.
8. Follow the maintenance instructions specified in the manual

Important Warnings

Failure to observe warnings will void warranty and/or cause injury.
1. Do not let the pressure washer overheat. Excess heat will cause severe
damage (see below for details).
2. Never run the unit without water. Running the pump dry will cause it to
quickly fail.
3. Do not let the unit freeze. Frozen water in the pump will cause serious
damage.
4. Always wear eye protection when operating the unit.
5. High pressure spray can cause serious bodily injury of damage soft
material. Use with caution.
6. Never adjust unloader to exceed the preset pressure. Premature wear,
equipment failure, or injury may occur.
6
SAFETY
.
WWW.BEPOWEREQUIPMENT.COM
SAFETY
Motors are air cooled. It is important to ensure that machine is operated in a
well-ventilated area where it can draw a steady supply of fresh air. The arrows
below show an example of locations for air intake on an engine.
Pumps are water cooled. When the machine is running, ensure the trigger
of the gun is pressed to allow a constant flow of fresh water into and out of
the pump. Do not let the machine run for more than 30 seconds without
pressing down on the trigger.
axial pump
Most pumps are protected by a thermal valve. The thermal valve releases
water if a pump starts to run too hot. It will prevent catastrophic heat failure.
However, the pump may have suffered damage and need maintenance, repair,
or replacement. If it does not reset and continues to leak water, the thermal
valve may need to be replaced.
leaks water to prevent
overheating
WWW.BEPOWEREQUIPMENT.COM
triplex pump
threaded into pump
with teflon tape
7