Shutting Down Your Washer - BE 66DX40GG1 Mode D'emploi

SHUTTING DOWN YOUR WASHER

WARNING
Contact with muffler area can result in serious burns.
Exhaust heat/gases can ignite combustibles, structures or
damage fuel tank causing a fire.
• DO NOT touch hot parts and avoid hot exhaust gases.
• Allow equipment to cool for at least 15 minutes before touching.
• Keep at least 5 feet (1.5 m) of clearance on all sides of pressure washer
(including overhead) while in operation.
How to Shut Your Pressure Washer Down
1. Release spray gun trigger and let engine idle down.
2. Turn the engine switch to the OFF position.
3. ALWAYS point spray gun in a safe direction, squeeze spray gun
trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even when engine
is stopped and water is disconnected. Couplers will not release if
under pressure.
24
WWW.BEPOWEREQUIPMENT.COM
ELECTRIC WASHER COMPONENTS
The following diagram is intended for general reference.
Your pressure washer may differ from the model shown below.
For specific model information, please visit our website
www.bepowerequipment.com
5.
1.
2.
4.
1. ON/OFF Switch
2. Motor
3. Pump
4. Flat-Free Tires
5. Soap Hose
6. Adjustable Unloader Knob
(Not included on all models)
7. Water Outlet
(appearance may vary by model)
8. Water Inlet
(appearance may vary by model)
9. High Pressure Hose
10. Gun/Wand Assembly
(appearance may vary by model)
11. Quick Connect Nozzles
WWW.BEPOWEREQUIPMENT.COM
10.
6. 11.
3.
9.
7.
8.
25