How To Shut Down Your Pressure Washer; Shutting Your Electric Washer Down; Spray Tips; How To Use Spray Tips - BE 66DX40GG1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SHUTTING YOUR ELECTRIC WASHER DOWN

How to Shut Down Your Pressure Washer

1. Release spray gun trigger.
2. Turn the motor switch to the OFF position.
3. ALWAYS point spray gun in a safe direction, squeeze spray gun trigger to
release retained high water pressure.
IMPORTANT: The spray gun traps high water pressure, even when the motor is
stopped and water is disconnected. Couplers will not release if under pressure.
WARNING
The high pressure stream of water that this equipment
produces can cut through skin and its underlying tissues,
leading to serious injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause injury.
• Keep high pressure hose connected to pump and spray gun while system
is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray gun trigger,
to release high pressure, every time you stop engine.
32
WWW.BEPOWEREQUIPMENT.COM

SPRAY TIPS

0
15
o
o
RED
YELLOW

How to Use Spray Tips

The quick–connect on the nozzle extension allows you to switch between
four different quick connect spray tips. Spray tips can be changed while the
pressure washer is running once the spray gun trigger safety lock is engaged.
The spray tips vary the spray pattern as shown above.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect coupler and pull the current spray tip off.
Store the spray tips in the holder provided on the handle. Storing nozzles in
the designated holder will help prevent any debris from clogging the tip.
2. Select the desired spray tip:
• For a gentle rinse, select the white 40° spray tip.
• For high pressure cleaning, select the yellow 15° spray tip.
• To scour the surface, select the red 0° spray tip.
• To apply detergent, select the black spray tip.
3. Pull back on collar, insert new spray tip and release collar. Tug on spray tip
to make sure it is securely in place.

Usage Tips

• For most effective cleaning, keep spray tip 8 to 24 inches away from clean-
ing surface.
• If you get spray tip too close, especially using a high pressure spray tip (red
or yellow), you may damage the surface being cleaned. Do not use the red
spray tip on glass.
WWW.BEPOWEREQUIPMENT.COM
40
o
soaper
WHITE
BLACK
33

Publicité

Chapitres

Table des Matières
loading

Table des Matières