Hama High-End Mode D'emploi page 25

Original:
Original size (4:3 format)
Smart:
Original size (4:3 format)
TROUBLESHOOTING:
The picture frame can not be switched on:
Cause: Problem with the electrical supply of the picture
screen.
Check that the plug of the power adapter is connected
correctly and completely. Also check that the power
supply unit is connected to the power supply and
supplied with electricity
.
The picture frame can no longer be operated when
selecting files:
Cause: Safety violation in the internal software of the
digital picture frame.
This may be due to the file format used. There are some
configurations that cause the software of the digital
picture frame to crash. However, the cause does not
26
With the „Normal" setting, the image keeps
its original format
With the „Smart" setting, the image is
adjusted to fit the size of the display
lie with the technology/software of the digital picture
screen, but with the file convention of the file to be
displayed or played. If the digital picture frame can
not be restored using the EXIT button in the function
selection menu or can not be switched off, disconnect
the picture frame from the mains supply. Reconnect it
and switch it on again after a few seconds.
Films/images (according to the device specification)
appear out of focus or grainy on the display
Cause: the data rate/quality or resolution is too low
The quality loss of images is caused by compression
and insufficient resolution. If it is possible to have a
higher resolution for the data, use this when displaying
or playing files.