Care And Maintenance; Inspection; Spare Parts - Xylem Goulds Ditch Wizard Manuel D'instructions

CLEANING
If the pump has been running in very dirty water, let it
run for a while in clean water, or flush it through the
discharge connection. If clay, cement or other similar
dirt is left in the pump it may clog the impeller and seal,
preventing the pump from working.
During a long period of storage, the pump must be test
run every other month to prevent the mechanical seals
from sticking together.
Watch out for the starting jerk, which can
WARNING
be powerful.
Always lift the pump by its carrying handle
WARNING
or lifting eyes, never by the motor cable or
the hose.

Care and Maintenance

INSPECTION

Regular inspection and preventive maintenance ensure
more reliable operation.
The pump should be inspected at least twice a year, more
frequently under severe operating conditions.
TIGHTENING SCREWS
During assembly or service of the pump we recommend
that the screws be tightened to approximately
4.5 - 6 ft lbs (6-8Nm).
This tightening torque ensures that the parts are correctly
fastened and that the pump will operate as intended.
NOTICE: Make sure that the oil-plug screw is not
overtightened.
Be sure to disconnect the power supply
WARNING
before attempting inpection, as the pump
may start automatically.
LUBRICATING SCREWS
To maintain screw tightness use a little mineral oil on all
non-stainless screws (non-synthetic lubricants!).
NOTICE: When using stainless steel screws on stainless
steel parts we recommend that ARAL DEGOL
GS 460 or National Chemseal THREAD-EZE
lubricants be used to prevent screws from
seizing or getting stuck.
If the motor cable on this pump is damaged
WARNING
the cable may only be changed by a repair
shop authorized by the manufacturer. This is necessary as
special tools are required to change the cable.

Spare Parts

SPARE PART KITS
Spare parts for the dewatering pumps are available in kits
to make service and repair work easier. Each kit contains
an instruction sheet with the replacement parts.
Kit type ½ HP
60Hz, Kit No.
Impeller Kit 15K11
Diffuser Kit 15K13
Outer Seal Kit 15K14
Each Kit contains the following parts:
Impeller Kit Impeller, Impeller screw,
Protective plug, Washer,
Assembly instruction
Diffuser Kit Diffuser, Barrel nuts, Screws,
Washers, Assembly instruction
Outer seal Kit Mechanical face-seal unit,
Assembly instruction
Please contact your local distributor for further details
regarding spare parts etc.
Components
Components
Item No. Description
1 Discharge
2 Power cord
3 Handle/cover
4 Support bearing
5 Pump casing
6 Main bearing
7 Inner mechanical seal
8 Outer mechanical seal
9 Impeller
10 Suction cover
11 Strainer
12 Oil plug
13, 14 Motor
3
14
13
12
10
11
1 HP
60Hz, Kit No.
15K12
15K13
15K14
2
1
4
5
6
7
8
9
5