Leister WELDPLAST S1 Notice D'utilisation page 27

Working display overview
Standby
If standby mode is activated
and the user does not press
a key on the operating unit or
the on/off switch for drive
(2) during the time set as
the «Standby Interval», the
device automatically switches
to the standby display. If
the user does not press the
«Confirmed» key (25)
in the next 180 seconds, cool
down mode starts automati-
cally.
Duty Info
Hours Drive: Current runtime
of the drive (can be reset).
Hours Blower: Current run-
time of the blower.
Hours Machine: Current
runtime of the machine.
General Info
Firmware HMI: Software
version of the display unit
(communication module).
Firmware Machine: Software
version of the output unit.
Production Info: Information
about the production date.
Warnings
If there is a warning pending,
this is indicated by the
symbol in the status
display. The «Warnings»
menu contains more detailed
information about the current
warning.
Machine Setup
The machine settings are
described in detail in the
«Machine Setup» chapter.
Application Mode
If „Application Mode" is
activated, the operating
display will provide detailed
information on the actual
plasticizing temperature
and the capacity utilization
of the hot-air blowers and
plasticizing heating.
Plast : 80 % 222 °C
Heat : 40 % 197 °C
Amb. :
Mains :
If «Show Set Values» is
activated, both the actual
temperature (large font
size) and the set tempera-
ture (small font size) are
displayed.
Reset to defaults
If the "Reset to defaults"
menu is selected and
confirmed by selecting the
relevant function ,
all customer-specific profiles
will be deleted. Settings that
have been changed via the
Setup menu will be reset to
the factory settings.
25 °C
50 Hz
27