Leister WELDPLAST S1 Notice D'utilisation page 25

Function and working display
• On the function and operating display, the field or icon
that is highlighted always indicates what is currently
selected.
• The actual values are always shown in the working
display, unless an item is selected, in which case the
setpoint is displayed.
• If «Show Set Values» is activated, both the actual
value and the setpoint are displayed (small font size).
Function display (27)
Select freely definable and predefined
profiles
Settings
Return to working display
(exits a menu directly)
Switch LED on/off.
This function is only available if the LED
has been activated.
Go back one level
Reset settings or hour counter
Service menu
(can only be accessed by entering the
password)
Save
Delete the selected item
Edit the selected item
Start cooling process
Function display (28)
Setpoint:
Drive output volume [%]
Setpoint:
Plasticizing temperature [°C/°F]
Setpoint:
Air temperature [°C/°F]
Setpoint:
Air volume [%]
Information box
The arrow pointing upward and the
progress bar indicate that the setpoint
(shown on the progress bar) has not yet
200
°C
been reached (too cold). The flashing
230
value is the actual value. The value
next to the progress bar is the setpoint.
The arrow pointing downward and the
progress bar indicate that the setpoint
(shown on the progress bar) has not yet
250
°C
been reached (too hot). The flashing
230
value is the actual value. The value
next to the progress bar is the setpoint.
If «Show Set Values» is activated,
both the actual temperature (large font
250
°C
size) and the set temperature (small
230
font size) are displayed.
Cooling process
Device in standby mode. Once the
counter has counted down, the device
will start «Cool down mode».
An error has occurred. An error code
also appears (the device is no longer
ready for use). Contact an authorized
service center.
Heating element air faulty
Device temperature too high.
Allow the device to cool down.
25